Xs1930-10 flow control?

Options
Skyeci26
Skyeci26 Posts: 3 image  Freshman Member
First Comment
in Switch

Hi.

I recently bought an xs1930-10. I'm trying to establish what the default firmware setting is with regards to flow control. I can't see it in any menus on the port setup and I asked support via a question but didn't get a answer either.

Does anybody know if its on or off or doesn't exist on default setup?

I have implemented the switch within my 10gb network so am trying to establish what is the best practice with regards to flow control within a 10gb network for this switch and what it's default setting is.

Many thanks for any help

Accepted Solution

  • Zyxel_Judy
    Zyxel_Judy Posts: 2,598 image  Zyxel Employee
    Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 2 - Switch Zyxel Certified Network Engineer Level 2 - Security Zyxel Certified Network Engineer Level 1 - Nebula
    edited November 2024 Answer ✓
    Options

    Hi @Skyeci26 ,

    Please note: The XS1930 does not currently support Flow Control when managed through Nebula. If your Nebula switches support Flow Control, you can configure it at Configure > Switches > Switch Port.

    image.png

    Please refer to the table below for a list of Nebula switches that support Flow Control:

    image.png

    Zyxel_Judy

All Replies

  • Zyxel_Judy
    Zyxel_Judy Posts: 2,598 image  Zyxel Employee
    Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 2 - Switch Zyxel Certified Network Engineer Level 2 - Security Zyxel Certified Network Engineer Level 1 - Nebula
    edited November 2024
    Options

    Hi @Skyeci26 ,

    We believe that your XS1930-10 is managed by Nebula Cloud, so flow control configuration is not available locally. When an XS1930-10 is managed by Nebula, you must access the Nebula portal to implement switch settings.

    Zyxel_Judy

  • Skyeci26
    Skyeci26 Posts: 3 image  Freshman Member
    First Comment
    Options

    How though. I can't find any menus relating to flow control anywhere.

  • Zyxel_Judy
    Zyxel_Judy Posts: 2,598 image  Zyxel Employee
    Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 2 - Switch Zyxel Certified Network Engineer Level 2 - Security Zyxel Certified Network Engineer Level 1 - Nebula
    edited November 2024 Answer ✓
    Options

    Hi @Skyeci26 ,

    Please note: The XS1930 does not currently support Flow Control when managed through Nebula. If your Nebula switches support Flow Control, you can configure it at Configure > Switches > Switch Port.

    image.png

    Please refer to the table below for a list of Nebula switches that support Flow Control:

    image.png

    Zyxel_Judy

  • Skyeci26
    Skyeci26 Posts: 3 image  Freshman Member
    First Comment
    Options

    OK thanks. Your chart confirms the xs1930 I have doesn't support it.

Categories

Switch Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）