Missing CLI commands on XS1930-12HP

peos42
peos42 Posts: 15  Freshman Member
First Comment Friend Collector

Hi

I am new to this forum. Have used an old zyxel switch before, but now I am back on zyxel again. Just bought an XS1930-12HP.

I have just installed it and done some test by configuring some VLAN trunks and other stuff. Seems to work as expected. Interesting that it takes 5-10% CPU when idling though…

I have bought and activated the access L3 license and therefor configured my VLAN stuff over the CLI (used cisco style "clv").

Now… I have upgraded to the latest firmware "V4.80(ABQF.4) | 08/23/2024". Now I am looking into the CLI guide "XS1930-12HP_V4.80-4.90_Ed1-CLI.pdf" where I can see there is commands for "sfp" and "slot".

There is simply no "show sfp" or "show slot" command in the switch, but there is in the CLI guide. No matter what mode and privilege I have… What am I missing?

Thanks in advance

//Peo

Accepted Solution

  • Zyxel_Melen
    Zyxel_Melen Posts: 2,526  Zyxel Employee
    Zyxel Certified Network Engineer Level 1 - Switch Zyxel Certified Network Administrator - Switch Zyxel Certified Network Administrator - Nebula Zyxel Certified Sales Associate
    Answer ✓

    Hi @peos42

    Thanks for your input. Please use the command "show interface transceiver XX" to display the SFP information. XX is the port number of your SFP port. We will edit the CLI reference guide since the command "show sfp" has not been used for some time.

    The "show slot" command is for the stacking slot information. The CLI reference guide is for the "Ethernet Switch Series", but XS1930 doesn't support the stacking function, so you cannot use this command.

    Zyxel Melen


All Replies

  • Zyxel_Melen
    Zyxel_Melen Posts: 2,526  Zyxel Employee
    Zyxel Certified Network Engineer Level 1 - Switch Zyxel Certified Network Administrator - Switch Zyxel Certified Network Administrator - Nebula Zyxel Certified Sales Associate
    Answer ✓

    Hi @peos42

    Thanks for your input. Please use the command "show interface transceiver XX" to display the SFP information. XX is the port number of your SFP port. We will edit the CLI reference guide since the command "show sfp" has not been used for some time.

    The "show slot" command is for the stacking slot information. The CLI reference guide is for the "Ethernet Switch Series", but XS1930 doesn't support the stacking function, so you cannot use this command.

    Zyxel Melen


  • peos42
    peos42 Posts: 15  Freshman Member
    First Comment Friend Collector

    Ok. That explains it :)

    Tnx för the quick reply @Zyxel_Melen