nxc-2500 change psk key with cli

nxc_neuling

Hello!

over telnet after login ...

configure terminal

wlan-security-profile guest_sec wpa-psk blablablabla

write

exit

become the wpa-psk changed and on the gui correct showed but  wlan login dont work.

I think i need  some as "apply"  on the cli ?

on the gui, after wlan-psk rewrite and "OK" then works ...

Thanks in advance...

Zyxel_Panda

Hi @nxc_neuling

I can also reproduce this issue symptom with using CLI, we will check what's different between CLI and GUI in details and then update to you.

Best regards,
Zyxel Panda Chang

Zyxel_Panda

Hi @nxc_neuling

Please using below CLI command to change PSK

Router# configure terminal

Router(config)# wlan-security-profile guest_sec

Router(config-wlan-security guest_sec)# wpa-psk blablablabla

Router(config-wlan-security guest_sec)# exit

Router(config)# write

Router(config)# exit

Router#

Best regards,
Zyxel Panda Chang

nxc_neuling

Thanks a lot!

It's works !