Wan failover





Hi all ,
I have configured wan failover to use secondary connection when primary fails, but i have noticed that i have trunk load balancing configured ? is there a way to configure just to have wan failover without load balancing on trunk.
Thanks in advance
Adi
All Replies
-
Not done a failover but heres what might work
make two rounting rules
The highest one with like
Incoming = Interface
member = LAN1
Next hop
type = Interface
interface = wan1
Address Translation
Source Network Address Translation = outgoing-interface
Advance
check = Disable policy route automatically while Interface link down
check = Enable Connectivity Check
address ISP WAN gateway IP or 8.8.8.8
Lowest rule secondary connection
Incoming = Interface
member = LAN1
Next hop
type = Interface
interface = wan2
Address Translation
Source Network Address Translation = outgoing-interface
When checking ping fails the highest rule will disable to allow the lowest rule.
1 -
Hi @adi_dragnic,
You can create an "User Configured Trunk" and add the secondary wan as "Passive" mode.
Then select this WAN Trunk to replace the system default one.
1 -
Categories
- All Categories
- 434 Beta Program
- 2.7K Nebula
- 174 Nebula Ideas
- 117 Nebula Status and Incidents
- 6.1K Security
- 418 USG FLEX H Series
- 297 Security Ideas
- 1.6K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 43 Wireless Ideas
- 6.7K Consumer Product
- 269 Service & License
- 416 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.1K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 83 About Community
- 87 Security Highlight