NWA50AX-PRO Country Code

fsardone

Good Morning,

I am deployng a small setup of 3 NWA50AX-PRO all wired into 2 different switches with multigibit interfaces. The 2 switches are interconnected between them with 10Gb trunk. The NWA are configured as AP and roaming is enabled on the 5 Ghz Profile. Stand Alone config, no nebula (the management network has no DHCP or Internet connectivity for security reasons), I am happy with using CLI (I am old school Cisco trained).

The AP have native VLAN 1 on interfaces (the VLAN 1 network is only management and does not carry user traffic). Traffic is on VLAN 2/4 and 9 which are associated to SSID. Radio 1 is configured according to default profile and radio 2 according to default1.

SSID profiles are similarly configured on both radios with similar names (duplicate names are not allowed) and identical SSID for the 2.5 Ghz radio 1 and the 5Ghz radio2. Roaming between the three AP works fine and the AP are configured with static IP.

No issues reported (finger crossed). But I just realized that on one of the AP I never ran the wizard so I did not set the country code to IT. while on the others I cancelled the wizerd only after setting the country code and IP address.

Couple of questions:

-Is there a way to check what country code the AP is operating and resetting it to what it is needed? Or do I need to reset to factory defaults and then run the wizard up to the point of country selection?

-I the setup correct (i.e. it is ok to have multiple AP in AP mode with overlapping coverage areas in order to facilitate roaming) or there is a way to administer all of them in a centralized way (i.e. one of them operating as primary, mirroring config like SSID/VLAN) or do I need to set each of them individually as I did?

-If I understand correctly, a single security profile can be applied to multiple SSID within each AP so when I modify PWD in that profile it is modified in all profiles using it, correct?

Thank you for your time and support.

Fabio