DX3301-T0 Telnet



I have just installed a new DX3301-TO. When I try and access by ssh I get the incorrect host key message. When I try and telnet in it refuses to connect. In Maintenance > Remote Management telnet is not listed.
How do I install a correct host key and how do I add telnet for remote maangement, please?
All Replies
-
Telnet is activated by default (only via local Lan) but you cannot configure it in the menu section, you can try this and check out if you make a fault using your SSH client .
But i revieved this and i forgot that i activated telnet (and ftp too) by changing the exported config file in the ftp and telnet section and then reimported it by adding a value in the line ["Mode":"LAN_withoutWL",]which was empty before like this ["Mode":"",] !
1 -
Sorry for the delay in getting back to you. Been away for a few days. Busy at the moment but will try the config file hack when I get the time to sit down and work things through.
Thanks for the help.
0
Categories
- All Categories
- 438 Beta Program
- 2.7K Nebula
- 188 Nebula Ideas
- 121 Nebula Status and Incidents
- 6.2K Security
- 454 USG FLEX H Series
- 303 Security Ideas
- 1.6K Switch
- 81 Switch Ideas
- 1.3K Wireless
- 44 Wireless Ideas
- 6.8K Consumer Product
- 278 Service & License
- 435 News and Release
- 88 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.2K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 91 Security Highlight