NWA130BE - Mesh / Traffic
I just installed two NWA130BE in my home. So far, I am not massively impressed but I'll give it time to figure out.
One question I have is why does a 'client' show connected to both wireless devices as per the screenshot.
Is this expected or additional routing for no reason?
Keeping in mind, my main floor is plugged into my router's switch and my Upst is also plugged into my routers switch. Both these APs are ethernet back-hauled back to the main router and no mesh is needed.
All Replies
-
Hi @lcohen999,
So, your topology is like below?
This could be because the router forwards the LLDP packets causes two APs to learn multiple LLDP info on the uplink port. And causes topology problem.
Zyxel Melen0 -
Yes, that is correct.
I am using a Mikrotik router but there is no additional routing which would cause this to happen.
Further to this, I only see this behaviour on devices which connect to MAIN FLOOR. They are route to UPST but anything directly connected to UPST does not. It seems like there is some sort of smart mesh rule going on
0
Categories
- All Categories
- 431 Beta Program
- 2.6K Nebula
- 164 Nebula Ideas
- 112 Nebula Status and Incidents
- 6K Security
- 362 USG FLEX H Series
- 292 Security Ideas
- 1.5K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 42 Wireless Ideas
- 6.6K Consumer Product
- 263 Service & License
- 407 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.9K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 83 Security Highlight