px3321-t1 ethernet port as wan



I have a PX3321-T1 I found on the street, it's working well and I wanted to use as the main router, but there is a problem, my isp has a pon mac filter that only allow the pon they installed to be connected.
So I only have two options: change the pon mac address or use one of the ethernet ports as a wan to connect to the internet.
Is there a way of doind this?
All Replies
-
I also found this command in ssh: sys atgs <GPONVendorID> <GPONSerialNumber> but it only says "Access denied!"
0 -
I think you have to register this device replacing your first registered device , there only can be one device registered over the ISP . It is shared medium and so only one correct user device has to be adressed .
The device seems to have no WAN Port extra , you can look if it is possible configure in the broadband section an new WAN connection type "Ethernet" "ETH" sometimes it is possible to replace a WAN port with a normal Ethernet port mostly Lan1 . If this is possible you could use it as a external firewall Wlan Router with any type of Modem not only Gpon ONT .
0 -
The only way I found to use it here was disabling DHCP and using it as a secondary router, but I wanted to use it as a primary router but there is no option to use ethernet as wan, only gpon
0
Categories
- All Categories
- 431 Beta Program
- 2.6K Nebula
- 164 Nebula Ideas
- 112 Nebula Status and Incidents
- 6K Security
- 362 USG FLEX H Series
- 292 Security Ideas
- 1.5K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 42 Wireless Ideas
- 6.6K Consumer Product
- 263 Service & License
- 407 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.9K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 84 Security Highlight