Weird Problem with WAN?!

Options
Username_is_reserved
Username_is_reserved Posts: 115  Ally Member
First Comment Friend Collector Sixth Anniversary

Well I dont know how but since my ISP Upgradet my Internet to an higher speed everything is weird… No HW changed. I also use the Zyxel Modem from my ISP. The "Dial In" does my ATP.

When I go to Ethernet i see this:

w1.JPG

The show me an 100.X.X.X IP Adress as WAN IP.

When I go to PPP I see this:

w2.JPG

Here I see my fix Wan IP Adress startet 185.X.X.X that is the one who I got from my ISP to access from WAN into my System.

Now the weird thing! When I going to any IP checking Site now the show me an 185.17.X.X IP Adress?? Where does the come from? (Yes it is NOT my fix WAN IP)

So where do I set something that the ATP using my fix WAN IP? So embarrassing. 😪

All Replies

  • PeterUK
    PeterUK Posts: 3,869  Guru Member
    100 Answers 2500 Comments Friend Collector Seventh Anniversary
    edited July 7

    Don't know much about PPPoE and think I would not like how it works.

    So the WAN is getting 100. which I guess is 100.64.0.0–100.127.255.255 ? used for CGNAT my guess is you are SNAT off this from some WAN IP that is not your WAN IP by PPPoE

    If you make a routing rule like
    incoming any or LAN
    nexthop your PPPoE interface
    SNAT outgoing-interface

    Then you will use your WAN IP

    or you can set up a trunk with your PPPoE set by User Configured Trunk

  • Zyxel_Tina
    Zyxel_Tina Posts: 46  Zyxel Employee
    Zyxel Certified Network Administrator - Security Zyxel Certified Network Administrator - Switch 5 Answers First Comment

    Hi @Username_is_reserved,

    Thanks for the detailed information!

    To better assist you, please provide your device's diagnostic file via private message. You can refer to this FAQ for instructions on how to collect the diagnostic file.

    Zyxel Tina