Replace ATP200 with Flex200H

TAPTech

If I replace my Nebula ATP200 firewall with a Flex 200H, will it copy the settings over, or will I need to start from scratch?

Zyxel_Tina

Hi @TAPTech,

Unfortunately, because your ATP200 and USG Flex 200H are managed by Nebula, direct configuration migration using a converter tool is not supported for this specific scenario. You will need to manually reconfigure the settings on your USG Flex 200H. Thank you for your understanding.

MCFH

Check the conversion tool

TAPTech

Thank you for the tip. I checked the conversion tool, however both of the Firewalls are on Nebula. It looks like the conversion tool is only for local/non-cloud.

Zyxel_Tina

Hi @TAPTech,

Unfortunately, because your ATP200 and USG Flex 200H are managed by Nebula, direct configuration migration using a converter tool is not supported for this specific scenario. You will need to manually reconfigure the settings on your USG Flex 200H. Thank you for your understanding.

TAPTech

https://community.zyxel.com/en/discussion/comment/78765#Comment_78765

Hi Tina,

Here is how I made it a bit easy- created a new Site in Nebula with the USGFlex200H and copied over the settings. Once the settings were complete, I move the switches and access points to the new site, then deleted the old site.