USG Lite 60AX Multiple SSID
Options
Got_Signal
Posts: 8 
Freshman Member
Freshman Member
in Security
I have a USG Lite 60AX, I am unable to provision multiple SSID. Only the first WLAN SSID will show, any additional just show up as HIDDEN. The settings are not set to hidden. It is current firmware V2.20(ACIP.0). I have reprovisioned, hard reset, tried tried and tried again. I have removed from site and recreated. I cannot figure out why. I have never had this issue with Zyxel Hardware. At this point I can only assume that it is a hardware issue.
0
All Replies
-
Hi @Got_Signal
It should broadcast all of the SSID that you set. May I know if the device's configuration status is up to date?
Or, could you enable Zyxel support access so we can help to check?
Zyxel Melen0
Zyxel Employee
Categories
- All Categories
- 442 Beta Program
- 2.9K Nebula
- 211 Nebula Ideas
- 127 Nebula Status and Incidents
- 6.4K Security
- 544 USG FLEX H Series
- 340 Security Ideas
- 1.7K Switch
- 84 Switch Ideas
- 1.3K Wireless
- 51 Wireless Ideas
- 6.9K Consumer Product
- 295 Service & License
- 465 News and Release
- 90 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.7K FAQ
- 34 Documents
- 87 About Community
- 99 Security Highlight
