How to migrate from USG 50 to USG 100?
Accepted Solution
-
Hi @follet,
It could be blocked because of mismatch physical interface. If so, i would suggest set up manually from beginning.5
All Replies
-
Hi @follet
Because it will check the model name of configuration file header when you apply configuration file to USG-100. It only accept the same model.
You can remove the first three line of the configuration file header to bypass checking and try it again.
(Please note that make sure the firmware version is same before your perform this operation.)
0 -
I see on my ZyXEL USG-100 firmware version is too old. I tried to update it, but it finished with error (see below)
File path depends on OS, I use Ubuntu. As for main topic, I can't restore USG 50 conf file even without 3 first rows...
0 -
Hi @follet ,
Updated wrong firmware, the firmware name should be “330AQQ7C0.bin”.
You can get correct firmware from link below.
Firmware link:
ftp://ftp2.zyxel.com/ZYWALL_USG_100/firmware/ZYWALL%20USG%20100_3.30%28AQQ.7%29C0.zip
0 -
Zyxel_Cooldia said:
You can remove the first three line of the configuration file header to bypass checking and try it again.
0 -
Yes, I done it manually.0
Categories
- All Categories
- 187 Beta Program
- 1.7K Nebula
- 91 Nebula Ideas
- 63 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 51 Switch Ideas
- 917 WirelessLAN
- 27 WLAN Ideas
- 5.4K Consumer Product
- 173 Service & License
- 296 News and Release
- 65 Security Advisories
- 14 Education Center
- 1K FAQ
- 450 Nebula FAQ
- 256 Security FAQ
- 100 Switch FAQ
- 115 WirelessLAN FAQ
- 22 Consumer Product FAQ
- 67 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 52 Security Highlight