Network Devices VLAN

Paolo_Fracas_1969

Hi all,
I would be create a VLAN (for example VLAN 4) where to manage all my network devices.
My Firewall have the IP 192.168.11.253 and have VLANs below:

VLAN1 default 192.168.11.x
VLAN4 Network Devices 192.168.4.x
VLAN110 Guest 192.168.110.x
VLAN120 Lab 192.168.120.x

I create the "Policy Control" rule to allow the services i need to connect from the LAN1 to VLAN4.
The Primary Switch is configured with all VLANs, have the port 1 connected with Firewall in Trunk and have IP 192.168.11.1.
Connected with the Primary switch there is a Secondary switch with the same configuration and IP 192.168.11.2.
Primary and secondary switch are connected with trunk ports.
If I change the IP of the Secondary switch in 192.168.4.2 (Gateway 192.168.4.253) I can ping it and have access to Web GUI.
If I change the IP of the Primary switch i can't ping it and I can't access to Web GUI.
Ping and access to Web GUI of the Secondary switch still alive.

What's wrong?
It's possible to do what I want?
I need to create some sort of Policy Route?

Thanks for all.

Paolo Fracas

PeterUK

Can you say what zone these VLAN are set to and what IP your trying to access the Primary switch from? from the looks of it is from 192.168.4.x but you want the Primary switch on 192.168.11.x correct?

does the Primary switch have a gateway IP?

Paolo_Fracas_1969

SOLVED

The Configuration of the Primary Switch was wrong.

I forget to setup the Management VLAN ID that was "1" and not "4".

Now all work fine.

Thank to all

Best Regards

Paolo Fracas