[USG Flex H - PoE support] - PoE management via SNMP

Maverick87

Hello everyone,

there is a possibility to control the PoE management (enable/disable/power reset) via SNMP? Also, there is a possibility via SNMP to check the PoE status (PoE status, PoE power, PoE class, overcurrent/error, current/voltage, etc etc)?

Zyxel_Luna

Hi Maverick87,

Thank you for sharing your feature requests with us.

Currently, the USG FLEX H series does not support the standard POWER-ETHERNET-MIB (RFC 3621) or any private Zyxel PoE MIBs.

Consequently, managing or monitoring PoE features via SNMP is not supported on USG FLEX H series firewalls.

We have forwarded your feedback as a feature request for future consideration, You can view and contribute to this idea in the following section:

https://community.zyxel.com/en/discussion/33753/usg-flex-h-poe-management-via-snmp

Thank you for using Zyxel products and service.

Zyxel_Luna

Hi Maverick87,

Thank you for sharing your feature requests with us.

Currently, the USG FLEX H series does not support the standard POWER-ETHERNET-MIB (RFC 3621) or any private Zyxel PoE MIBs.

Consequently, managing or monitoring PoE features via SNMP is not supported on USG FLEX H series firewalls.

We have forwarded your feedback as a feature request for future consideration, You can view and contribute to this idea in the following section:

https://community.zyxel.com/en/discussion/33753/usg-flex-h-poe-management-via-snmp

Thank you for using Zyxel products and service.