[USG Flex H - PoE support] - PoE management via SNMP
Master Member
Hello everyone,
there is a possibility to control the PoE management (enable/disable/power reset) via SNMP? Also, there is a possibility via SNMP to check the PoE status (PoE status, PoE power, PoE class, overcurrent/error, current/voltage, etc etc)?
Accepted Solution
-
Hi Maverick87,
Thank you for sharing your feature requests with us.
Currently, the USG FLEX H series does not support the standard POWER-ETHERNET-MIB (RFC 3621) or any private Zyxel PoE MIBs.
Consequently, managing or monitoring PoE features via SNMP is not supported on USG FLEX H series firewalls.
We have forwarded your feedback as a feature request for future consideration, You can view and contribute to this idea in the following section:
Thank you for using Zyxel products and service.
1
All Replies
-
Hi Maverick87,
Thank you for sharing your feature requests with us.
Currently, the USG FLEX H series does not support the standard POWER-ETHERNET-MIB (RFC 3621) or any private Zyxel PoE MIBs.
Consequently, managing or monitoring PoE features via SNMP is not supported on USG FLEX H series firewalls.
We have forwarded your feedback as a feature request for future consideration, You can view and contribute to this idea in the following section:
Thank you for using Zyxel products and service.
1
Categories
- All Categories
- 442 Beta Program
- 3.1K Nebula
- 237 Nebula Ideas
- 6.8K Security
- 740 USG FLEX H Series
- 376 Security Ideas
- 1.8K Switch
- 87 Switch Ideas
- 1.5K Wireless
- 58 Wireless Ideas
- 7.2K Consumer Product
- 319 Service & License
- 512 News and Release
- 99 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 5.3K FAQ
- 34 Documents
- 91 About Community
- 119 Security Highlight
Zyxel Employee