reset interface via script not working
Hello,
I use script to reset interface :
first :
configure terminal
interface O2_VDSL
shutdown
second :
configure terminal
interface O2_VDSL
no shutdown
schedule every night 2:00 and 2:01 in terminall
When I use fw 4.33 evething is OK ( interface go down and up ) Now I using fw 4.35 and when script run - interface is down ( in web is grey ) but still working ( I ping on it !!! ) In log I don´t see interface is down.
Thanks
Zdenek B
Accepted Solution
-
Hi @ZdenekB,
Here is the test result for your reference.
Model: USG210
Firmware: 4.35(AAPI.0)
Two scripts:
Commands:
Router(config)# schedule-run 1 shutdown_lan1.zysh daily 16:50
Router(config)# schedule-run 2 enable_lan1.zysh daily 16:58
Router(config)# write
Result:
The interface lan1 is disabled and enabled on schedule.
5
All Replies
-
Hi @ZdenekB,
Here is the test result for your reference.
Model: USG210
Firmware: 4.35(AAPI.0)
Two scripts:
Commands:
Router(config)# schedule-run 1 shutdown_lan1.zysh daily 16:50
Router(config)# schedule-run 2 enable_lan1.zysh daily 16:58
Router(config)# write
Result:
The interface lan1 is disabled and enabled on schedule.
5
Categories
- All Categories
- 384 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 79 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 909 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 209 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 898 Nebula FAQ
- 415 Security FAQ
- 234 Switch FAQ
- 205 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 62 Security Highlight