Site-To-Site IPSec VPN

Options
Drum
Drum Posts: 2
edited April 2021 in Security

How can I configure IPSec VPN Tunnel between USG60W and Cisco RV042G?

DDNS service is configured both routers.

USG60W:

WAN IP: usg60w.dyndns.org

Local IP: 192.168.100.1 255.255.255.0


RV042G:

WAN IP: rv042g.dyndns.org

Local IP: 192.168.200.1 255.255.255.0

All Replies

  • PeterUK
    PeterUK Posts: 2,706  Guru Member
    First Anniversary 10 Comments Friend Collector First Answer
    edited April 2020
    Options

    on the USG60W side make a VPN gateway tab with IKEv1 may address wan1 with peer gateway rv042g.dyndns.org enter Pre-Shared Key and ok then go to VPN connection tab make for site-to-site select your VPN gateway set local policy 192.168.100.1 255.255.255.0 and remote policy 192.168.200.1 255.255.255.0 go advance and check nailed-up make a zone TuneltoRV042G and set that for zone in VPN connection.

    firewall rules

    allow FROM wan1 TO ZyWALL service VPN group ESP, IKE, L2TP-UDP and NATT

    allow FROM TuneltoRV042G TO LAN1

    allow FROM LAN1 TO TuneltoRV042G

Security Highlight