USG310 port role mapping
Hello,
on the usg60/40/20 there was an easy way to map port roles to duplicated lan1 across multiple ports. On the USG310 there is no option for that. I tried to create a bridge and add ports into that bridge group but then when i try to assign dhcp for that bridge group it gives me an error message when trying to assign dhcp using the same ip scheme as my lan 1. Is there a way to have the bridge i created use dhcp from my lan 1 config?
on the usg60/40/20 there was an easy way to map port roles to duplicated lan1 across multiple ports. On the USG310 there is no option for that. I tried to create a bridge and add ports into that bridge group but then when i try to assign dhcp for that bridge group it gives me an error message when trying to assign dhcp using the same ip scheme as my lan 1. Is there a way to have the bridge i created use dhcp from my lan 1 config?
0
All Replies
-
Why not use a switch?
Give the ports for the bridge a non-usable IP like 127.255.255.1/255.255.255.252...127.255.255.5/255.255.255.252.
this should stop the error message when doing DHCP for the bridge.0
Categories
- 8.5K All Categories
- 1.6K Nebula
- 71 Nebula Ideas
- 57 Nebula Status and Incidents
- 4.5K Security
- 226 Security Ideas
- 983 Switch
- 46 Switch Ideas
- 878 WirelessLAN
- 22 WLAN Ideas
- 5.2K Consumer Product
- 157 Service & License
- 280 News and Release
- 59 Security Advisories
- 13 Education Center
- 580 FAQ
- 263 Nebula FAQ
- 160 Security FAQ
- 76 Switch FAQ
- 74 WirelessLAN FAQ
- 7 Consumer Product FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 69 About Community
- 46 Security Highlight