fqdn in policy rule in zywall 110
is there a way to set up a policy to allow one or more Fully Qualified Domain Names (FQDN) through the firewall? i.e. instead of setup up a bunch of specific ip addresses which may change from time to time, I'd like to specify a set of FQDN's.
#Biz_Security_November
#Biz_Security_November
0
All Replies
-
As i check on my device, the address object does not support FQDN on ZyWall/USG series(V4.25),
Not sure will it support in the future.
I think we can inquiry on USG forum https://businessforum.zyxel.com/categories/security-zywall-usg-series
0 -
Thanks for the reply ialaland ... same conclusion I came to. Running same firmware version as you too. Thanks again.
0
Categories
- All Categories
- 428 Beta Program
- 2.6K Nebula
- 163 Nebula Ideas
- 112 Nebula Status and Incidents
- 6K Security
- 346 USG FLEX H Series
- 290 Security Ideas
- 1.5K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 42 Wireless Ideas
- 6.6K Consumer Product
- 261 Service & License
- 404 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.8K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 82 Security Highlight