Why the USG trunk profile cannot work as expect, the traffic always went to wrong interface?
Zyxel_Charlie
Posts: 1,034
Guru Member
Guru Member
Please check policy route rule trunk profile status, dead or alive.
The status depends on Interface “Connectivity Check”, what if you set up an improper host to perform connectivity Check, it always in dead status, that why the traffic always go to wan 2.
Try to adjust a suitable one as “connectivity check” host and try it again.
The status depends on Interface “Connectivity Check”, what if you set up an improper host to perform connectivity Check, it always in dead status, that why the traffic always go to wan 2.
Try to adjust a suitable one as “connectivity check” host and try it again.
Tagged:
0
Categories
- 7.2K All Categories
- 6 Education Center
- 1.4K Nebula
- 39 Nebula Ideas
- 46 Nebula Status and Incidents
- 4.1K Security
- 206 Security Ideas
- 790 Switch
- 34 Switch Ideas
- 679 WirelessLAN
- 11 WLAN Ideas
- 4.7K Consumer Product
- 113 Service & License
- 234 News and Release
- 43 Security Advisories
- 546 FAQ
- 258 Nebula FAQ
- 124 Security FAQ
- 73 Switch FAQ
- 68 WirelessLAN FAQ
- 7 Consumer Product FAQ
- Documents
- 30 Nebula Monthly Express
- 54 About Community
- 34 Security Highlight