GS1900-8HP login

bilbo

I am able to login to the GS1900-8HP using Windows 10 and setting a static address 192.168.1.10.  I changed these settings: admin password, SNMP Global State to disable, SNMP Group string from "public" to "nonpublic."   This eliminated the warning at the start of the GUI for Admin Password and SNMP Public settings.

PROBLEM: I cannot access the switch from Linux when the switch is in a reset state, or after power loss.  After reset / power loss the switch defaults to a static addressing and I can access the switch from Windows 10  using 192.168.1.10, but I cannot access it using Linux.  Either, I am not setting up Linux Static Addressing correctly or the Linux GUI for Static Addressing is buggy.  I have not used Linux command line networking.

When I set the switch to dynamic addressing I am able to access the switch login and login appropriately with Linux.

I DO NOT want to rely on Windows 10 to access this switch after power off.


#Biz_Jun_2019

Wiasouda

I think you should post this discussion to ZYXEL BIZ FORUM - Switch, it would be got quickly support. https://businessforum.zyxel.com/categories/switch

bilbo

No one works with Linux and this switch?