USG60 - VLAN-Configuration - No Product/Mac-Address/DNS on Network-Ping

FrancescoCH
Posts: 1
Hi Community,
now I've run out of ideas where to continue.
I've set-up some VLANs with own subnets. Everything works fine up to here. DHCP IP-Assignments works fine. But!
If I assign the LAN1 IP-Adress to a Wireless-Equipment then on an IP-Scan the IP-Adress, the network Name, Mac-Address, Product, Producer, DNS etc. all is present.
If I assign the same equipment to e.g. VLAN1 then on an IP-Scan a proper IP is assigned but NO Name, Mac-Address, Product etc. is shown - it's stated as unknown.
A hint, a push in the right direction would be highly appreciated.
Thanks
Francesco
now I've run out of ideas where to continue.
I've set-up some VLANs with own subnets. Everything works fine up to here. DHCP IP-Assignments works fine. But!
If I assign the LAN1 IP-Adress to a Wireless-Equipment then on an IP-Scan the IP-Adress, the network Name, Mac-Address, Product, Producer, DNS etc. all is present.
If I assign the same equipment to e.g. VLAN1 then on an IP-Scan a proper IP is assigned but NO Name, Mac-Address, Product etc. is shown - it's stated as unknown.
A hint, a push in the right direction would be highly appreciated.
Thanks
Francesco
0
Comments
-
Dear Sir,
If you have questions about USG, our agent will assist you there. https://businessforum.zyxel.com/categories/security
0
Categories
- 8.5K All Categories
- 1.6K Nebula
- 71 Nebula Ideas
- 57 Nebula Status and Incidents
- 4.5K Security
- 226 Security Ideas
- 981 Switch
- 46 Switch Ideas
- 874 WirelessLAN
- 22 WLAN Ideas
- 5.1K Consumer Product
- 157 Service & License
- 280 News and Release
- 59 Security Advisories
- 13 Education Center
- 580 FAQ
- 263 Nebula FAQ
- 160 Security FAQ
- 76 Switch FAQ
- 74 WirelessLAN FAQ
- 7 Consumer Product FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 69 About Community
- 46 Security Highlight