FW-Upgrade standard behaviour: -> "Ignore errors and finish applying the configuration file"
Options
mjr
Posts: 26 Freshman Member
In case of a failure during a FW-update (i.e. from v.4.33 to v4.35) the USG falls back to default config and will be in an unconfigured condition. There is no simple possibility to do further remote administration.
IDEA:
Please add a choice - before the FW-upgrade starts - like when applying a configuration file:
IDEA:
Please add a choice - before the FW-upgrade starts - like when applying a configuration file:
If applying the configuration file encounters an error:
-- Immediately stop applying the configuration file |
-- Immediately stop applying the configuration file and roll back to the previous configuration |
-- Ignore errors and finish applying the configuration file |
-- Ignore errors and finish applying the configuration file and then roll back to the previous configuration |
0
Comments
-
I agree that, at the bare minimum, it should be applying the last successful running configuration. I'd be surprised if it wasn't doing that already, though, unless, perhaps, the config you're currently using is failing to load properly in 4.33 and generating errors?
Incidentally, I haven't had a configuration fail, yet, but I'll be doing a swath of upgrades tomorrow, so I'll report back if I find the same issue.
0
Categories
- All Categories
- 384 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 77 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 209 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 898 Nebula FAQ
- 415 Security FAQ
- 234 Switch FAQ
- 205 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 62 Security Highlight