USG60W - WAN1/2 link speed
Hi Zyxel community,
is there a official document, about the link speed for WAN1/WAN2 at a USG60W ?
i've connected the USG60W directly to my INAC (InterNet Access Connect) Firewall with Intel GBit Ports, but USG show only 100 Mbit ? is 100 Mbit correct by ZyXEL ?
Thanks an Regards
Christian
All Replies
-
Hi @ChristianG,
Go to CONFIGURATION > Network > Interface > Port > Port Configuration and select 1000Mbps-Full Duplex on this port.
Connect wan1 directly to INAC Firewall again and check if the status of P1 is 1000M/Full.
0 -
Hi @Zyxel_Emily
thanks for your quick response. The Option Port is not visible on a USG60W [v4.32-WK52) ?
is this onyl visible in a newer firmware version for USG60W ?
Regards
Christian
0 -
Hi @ChristianG,
Yes. It is new GUI enhancement in firmware 4.35.
You can find this enhancement on page 22 of the release note.
0
Categories
- All Categories
- 397 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 87 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 916 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 912 Nebula FAQ
- 419 Security FAQ
- 237 Switch FAQ
- 207 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight