USG60W - WAN1/2 link speed

Options
ChrisGer
ChrisGer Posts: 206 image  Ally Member
Zyxel Certified Network Administrator - Switch Zyxel Certified Network Administrator - WLAN Zyxel Certified Network Administrator - Security Zyxel Certified Network Administrator - Nebula
edited April 2021 in Security

Hi Zyxel community,

is there a official document, about the link speed for WAN1/WAN2 at a USG60W ?

i've connected the USG60W directly to my INAC (InterNet Access Connect) Firewall with Intel GBit Ports, but USG show only 100 Mbit ? is 100 Mbit correct by ZyXEL ?


Thanks an Regards

Christian

All Replies

  • Zyxel_Emily
    Zyxel_Emily Posts: 1,462 image  Zyxel Employee
    Zyxel Certified Network Administrator - Security Zyxel Certified Sales Associate 100 Answers 1000 Comments

    Hi @ChristianG,

    Go to CONFIGURATION > Network > Interface > Port > Port Configuration and select 1000Mbps-Full Duplex on this port.

    Connect wan1 directly to INAC Firewall again and check if the status of P1 is 1000M/Full.

    image.png
  • ChrisGer
    ChrisGer Posts: 206 image  Ally Member
    Zyxel Certified Network Administrator - Switch Zyxel Certified Network Administrator - WLAN Zyxel Certified Network Administrator - Security Zyxel Certified Network Administrator - Nebula

    Hi @Zyxel_Emily

    thanks for your quick response. The Option Port is not visible on a USG60W [v4.32-WK52) ?

    zyxel-wan-port.jpg

    is this onyl visible in a newer firmware version for USG60W ?


    Regards

    Christian

  • Zyxel_Emily
    Zyxel_Emily Posts: 1,462 image  Zyxel Employee
    Zyxel Certified Network Administrator - Security Zyxel Certified Sales Associate 100 Answers 1000 Comments

    Hi @ChristianG,

    Yes. It is new GUI enhancement in firmware 4.35.

    You can find this enhancement on page 22 of the release note.

    image.png

Categories

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）