ZYSH daemon terminates. Restart daemon using telnet?
On a USG310 ( V4.25(AAPJ.1)C0), the ZYSH terminates unexpectedly while editing GEO-groups.
If the firewall is rebooted, ZYSH starts again. However, rebooting is unacceptable due to the interruption of service.
How can I can start the ZYSH daemon from Telnet without rebooting?
If the firewall is rebooted, ZYSH starts again. However, rebooting is unacceptable due to the interruption of service.
How can I can start the ZYSH daemon from Telnet without rebooting?
0
Comments
-
0
-
I got the same issue on ZyWALL 110 before.
When I try to modify the address group object, the error message pops up "Zysh Daemon is terminated".
Then the local support gave me the date firmware and the issue is resolved.
0 -
Hello InterLan,
We suggest to upgrade your device’s FW to the latest one firstly, this issue should had been fixed on this FW version.
The download link will be PM to you.
Charlie0 -
The issue was resolved by an interim release firmware upgrade.
Thank you, Charlie
0 -
I'm running into this same issue. USG60, v4.25(AAKY.1). I was able to upload a new conf file with the changes to my Address Groups. Is there an available patch?0
-
0
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 115 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 64 Switch Ideas
- 900 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 832 Nebula FAQ
- 402 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight