IPSec VPN to Azure

Options
SecureShell
SecureShell Posts: 2 image  Freshman Member
First Comment
edited April 2021 in Security

Hi, I am using USG20W-VPN device and using a dynamic public IP. I want to create a site to site VPN to Azure. I followed the procedures in the article described :

How to Configure Route-based IPsec VPN to Azure (VTI over IKEv2/IPSec)


But its not working. Can somebody help me.


Thanks in advance

All Replies

  • lalaland
    lalaland Posts: 91 image  Ally Member
    First Answer First Comment Friend Collector Sixth Anniversary
    edited January 2020

    Hello SecureShell,

    When you completed the setting, the issue you encounter was;

    1) VPN tunnel can build up successfully, but cannot ping to Azure virtual network host.

    or

    2) Just VPN tunnel build up fail?

    The way to trouble both case is different.?

  • SecureShell
    SecureShell Posts: 2 image  Freshman Member
    First Comment

    Hi Lalaland,

    Thanks for your response.

    I checked and found that the tunnel has been established, but I couldn't find any place at Zyxel console to find that information. I could only see this at Azure on Virtual Network Gateway (connected). I should have checked there first before making this post!

    Thanks anyway.

  • Zyxel_Vic
    Zyxel_Vic Posts: 323 image  Zyxel Employee
    25 Answers First Comment Friend Collector Eighth Anniversary

    Hi @SecureShell

    You may use "show sa monitor" in the console to realize the tunnel connection status

Categories

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）