Configure a USG110 to use PPPoE (DSL)?

BMS · March 2020

Is it possible to set up a direct PPPoE connection with a modem in bridged mode? I see it as some level of fallback option, not sure if it can really handle being the full authentication device and connection.

Basically, have a DSL modem that can be placed in bridged mode to assign an IP and use the USG110 as the gateway, but I need to make sure it will be able to handle that before I proceed.

Zyxel_Vic · March 2020

Hi @BMS

Do you just need to use the USG110 to dial up the PPPoE connection? (the modem running in bridge mode)

If so, you just need to :

Configure your ISP connection information in "Configuration" --> "Object" --> "ISP Account", there are some pre-configured profiles and you can just edit one of them
Configure the PPP interface in "Configuration" --> "Network" --> "Interface" --> "PPP" to build up a ppp interface, the configured ISP connection profile in step 1 will be applied in the PPP interface profile settings
Click on "Connect" button in the PPP setting page to trigger the device to dial up to the ISP

Zyxel_Vic · March 2020

Hi @BMS

Do you just need to use the USG110 to dial up the PPPoE connection? (the modem running in bridge mode)

If so, you just need to :

Configure your ISP connection information in "Configuration" --> "Object" --> "ISP Account", there are some pre-configured profiles and you can just edit one of them
Configure the PPP interface in "Configuration" --> "Network" --> "Interface" --> "PPP" to build up a ppp interface, the configured ISP connection profile in step 1 will be applied in the PPP interface profile settings
Click on "Connect" button in the PPP setting page to trigger the device to dial up to the ISP

Configure a USG110 to use PPPoE (DSL)?

Accepted Solution

All Replies

Categories

Security Help Center