impossible to configure NWA1123-ACv2 in standalone mode

Options

fmap

fmap Posts: 2

Freshman Member

First Comment

April 2020 edited May 2024 in Wireless

Hello,

I have a limited web interface on my NWA1123-ACv2. impossible to configure the device in standalone.

The device is in factory reset.

Only network menu.

ZON is unable to find the device.

If you have an idea...

Thank you

Capture d’écran 2020-04-08 à 15.09.40.png

0

Accepted Solution

Zyxel_Panda Posts: 97 Zyxel Employee

April 2020 Answer ✓

Hi @fmap
The device seems in nebula mode.
Has it been removed from the Org/site of Nebula?
Could you access its IP address by SSH session to type the following commands:
Router> show hybrid-mode
Router> show nebula claim status
Router> show nebula cloud status
Router> psm atsh
Please send above information to me by private message.

Thanks a lot !
Panda

5

All Replies

Zyxel_Panda Posts: 97 Zyxel Employee

April 2020 Answer ✓

Hi @fmap
The device seems in nebula mode.
Has it been removed from the Org/site of Nebula?
Could you access its IP address by SSH session to type the following commands:
Router> show hybrid-mode
Router> show nebula claim status
Router> show nebula cloud status
Router> psm atsh
Please send above information to me by private message.

Thanks a lot !
Panda

5
fmap Posts: 2 Freshman Member

April 2020

Now it's working.
Thanks

0
jpg Posts: 4 Freshman Member

September 2025

Hi,

I have the same problem with my NWA1123-ACv2.

Can you solve my problem too ?

0

Wireless Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）