SERVER WANtoLAN USG40
Options

antonellobellisario
Posts: 17
Freshman Member



Existing scenario:

how can I access via http to a lan client as show in the figure behind the server with 2 NICs and behind -USG40
HTTP ------->USG40>NIC_SERVER WAN > NIC_SERVER LAN >CLIENT_LAN

how can I access via http to a lan client as show in the figure behind the server with 2 NICs and behind -USG40
HTTP ------->USG40>NIC_SERVER WAN > NIC_SERVER LAN >CLIENT_LAN
0
Accepted Solution
-
@antonellobellisario
Regarding to your case,(One wan IP mapping to two lan server)
you need to configure the NAT rule with different port number, and then go to security policy to create the policy rule, source: any , destination: Lan servers' IP, Service: Http, allow.
EX:
1
All Replies
-
@antonellobellisario
Regarding to your case,(One wan IP mapping to two lan server)
you need to configure the NAT rule with different port number, and then go to security policy to create the policy rule, source: any , destination: Lan servers' IP, Service: Http, allow.
EX:
1
Categories
- All Categories
- 434 Beta Program
- 2.7K Nebula
- 174 Nebula Ideas
- 117 Nebula Status and Incidents
- 6.1K Security
- 418 USG FLEX H Series
- 297 Security Ideas
- 1.6K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 43 Wireless Ideas
- 6.7K Consumer Product
- 269 Service & License
- 416 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.1K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 83 About Community
- 87 Security Highlight