Configure vlan in atp 200
I have a Zyxell atp 200 firewall with 4 lan ports. and several unifi switches 16 and 24 ports.
right now I am connecting an unifi switch 16 ports to the firewall.
I would like to have:
firewall lan port 1 for vlan 1 and 20 connected to unifi switch port 1
firewall lan port 2 for vlan 10 connected to unifi switch port 2
firewall lan port 3 for vlan 30 connected to unifi switch port 3
firewall lan port 4 for vlan 40 connected to unifi switch port 4
The firewall should be giving the ip via dhcp for the vlans
In the firewall I configured:
lan 1 port to give an ip address via dhcp yyy.yyy.yyy.yyy
lan 2 port to give an ip address via dhcp aaa.aaa.aaa.aaa
lan 3 port to give an ip address via dhcp bbb.bbb.bbb.bbb
lan 4 port to give an ip address via dhcp ccc.ccc.ccc.ccc
vlan1 to give another range of addresses xxx.xxx.xxx.xxx
vlan 20 to give another range of addresses zzz.zzz.zzz.zzz
then selected for vlan 1 and vlan 20 to be on the lan 1 port of the firewal.
when i connect the swith to the firewall it gets the ip in the yyy.yyy.yyy.yyy range.
Is it the correct behaviour?
how can I check if the vlans are applied?
- 6.9K All Categories
- 2 Education Center
- 1.4K Nebula
- 34 Nebula Ideas
- 41 Nebula Status and Incidents
- 4K Security
- 204 Security Ideas
- 755 Switch
- 31 Switch Ideas
- 637 WirelessLAN
- 9 WLAN Ideas
- 4.6K Consumer Product
- 106 Service & License
- 225 News and Release
- 77 Stories
- 40 Security Advisories
- 525 FAQ
- 242 Nebula FAQ
- 121 Security FAQ
- 73 Switch FAQ
- 67 WirelessLAN FAQ
- 6 Consumer Product FAQ
- 30 Nebula Monthly Express
- 45 About Community
- 32 Security Highlight