About LoadBalance＆Disassociate behavior
Gogocar
Posts: 3 
Freshman Member
Freshman Member
In two stand-alone APs configuration and the same SSID environment, we want to connect to another AP as up to 20 clients in one AP.So, I activated the LoadBalance function (By Station Number) and checked Disassociate station when overloaded.
When two APs were connected with restriction set to 1, 2 or more connections were made.
After that, I waited for 5 minutes, but the phenomenon did not change.
Can you help me ?
When two APs were connected with restriction set to 1, 2 or more connections were made.
After that, I waited for 5 minutes, but the phenomenon did not change.
Can you help me ?
0
Comments
-
Hi @Gogocar,
If you want to test the load balance function with restriction set to 1 or 2 station in per AP, then the total test devices should be 2 or 4 units. To assure that there is other AP for station who is kicked to connect.
That's you can see load balance function works.
For the load balance mechanism, the AP would not real block station connecting when all the APs are overloaded.If you enable this function, you should ensure that there are multiple APs within the broadcast radius that can accept any rejected or kicked wireless clients.
Kathy0
Zyxel Employee
Categories
- 6.9K All Categories
- 2 Education Center
- 1.4K Nebula
- 34 Nebula Ideas
- 41 Nebula Status and Incidents
- 4K Security
- 204 Security Ideas
- 754 Switch
- 31 Switch Ideas
- 638 WirelessLAN
- 10 WLAN Ideas
- 4.6K Consumer Product
- 106 Service & License
- 225 News and Release
- 40 Security Advisories
- 525 FAQ
- 242 Nebula FAQ
- 121 Security FAQ
- 73 Switch FAQ
- 67 WirelessLAN FAQ
- 6 Consumer Product FAQ
- Documents
- 30 Nebula Monthly Express
- 45 About Community
- 32 Security Highlight
