How can I release IPs from the DHCP pool on NXC5200?

Running_MAN
Posts: 2
Freshman Member

Hi, I use NXC5200 as my DHCP server, but the DHCP pool is full now. The new clients cannot get IP but there have too many redundant users, how can I release them???
0
Comments
-
Hi @Running_MAN,
There is no command or function to clear the DHCP pool when the pool is full.
Our suggestion is shorten the lease time and re-open the DHCP server or reboot the NXC.
Re-opening the DHCP will interrupt the service for a while, but all the IPs will be released from the DHCP server.
1. Shorten the lease time.
2. After finish the setting, reboot the NXC.
or if you don't want to reboot the NXC, you can do as below
2. After finish the setting, disable the radio.
3. Disable the DHCP server.
Remember the settings of the DHCP server and set DHCP to "none". Press "Apply".
4. Set DHCP to "DHCP server" again and enter the configuration.
5. Enable the radio.
0
Categories
- 6.8K All Categories
- 1.4K Nebula
- 29 Nebula Ideas
- 38 Nebula Status and Incidents
- 3.9K Security
- 200 Security Ideas
- 723 Switch
- 30 Switch Ideas
- 601 WirelessLAN
- 8 WLAN Ideas
- 4.5K Consumer Product
- 98 Service & License
- 214 New and Release
- 38 Security Advisories
- 513 FAQ
- 236 Nebula FAQ
- 117 Security FAQ
- 74 Switch FAQ
- 65 WirelessLAN FAQ
- 5 Consumer Product FAQ
- Documents
- 30 Nebula Monthly Express
- 43 About Community
- 31 Security Highlight