No arpseal activate - permanent
Freshman Member
I have a problem with a particular internet service provide that is using these Hitron modems.
When configured for static ip mode, the modems seem to "announce" two MAC address same ip address "Possible arp spoof attack"
Needless to say the ISP is slow to respond. The quick fix is to invoke this command at the command line "no arpseal activate" but my understanding this is temporary.
Is there a way to make this permanent? Or to have it scripted on boot up?
When configured for static ip mode, the modems seem to "announce" two MAC address same ip address "Possible arp spoof attack"
Needless to say the ISP is slow to respond. The quick fix is to invoke this command at the command line "no arpseal activate" but my understanding this is temporary.
Is there a way to make this permanent? Or to have it scripted on boot up?
0
Accepted Solution
-
@dscope
You need tp enter command write to save the CLI:no arpseal activate.Router(config)# no arpseal activateRouter(config)# write
Charlie5
Zyxel Employee
All Replies
-
@dscope
You need tp enter command write to save the CLI:no arpseal activate.Router(config)# no arpseal activateRouter(config)# write
Charlie5 -
I see. I didn't realize that the parameter setting DOES get saved. For some reason it was mentioned to me that it doesn't.
Thank you very much0
Categories
- All Categories
- 439 Beta Program
- 2.7K Nebula
- 190 Nebula Ideas
- 121 Nebula Status and Incidents
- 6.2K Security
- 466 USG FLEX H Series
- 305 Security Ideas
- 1.6K Switch
- 81 Switch Ideas
- 1.3K Wireless
- 44 Wireless Ideas
- 6.8K Consumer Product
- 281 Service & License
- 440 News and Release
- 88 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.3K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 93 Security Highlight
