ATP200 Wan/Lan Bridge Mode with VLANs
Options

MartyWalter
Posts: 32
Freshman Member



We are installing an ATP200 between a customers VPN100 and their network (as suggested by ZyXEL sales). The VPN100 (in SDWAN mode) has the native VLAN as well as two VLANs for voice/guest traffic.
We are struggling with passing the Voice/Guest vlans across the bridged ATP200.
If anyone has a suggestions for the proper settings in the ATP200, it would be greatly appreciated.
We are struggling with passing the Voice/Guest vlans across the bridged ATP200.
If anyone has a suggestions for the proper settings in the ATP200, it would be greatly appreciated.
0
All Replies
-
@MartyWalter
Regarding to your description,
the configuration of Vlan on VPN100 need to configure untag, and bridge Wan and Lan interface on ATP200 then check it again.
0 -
This is exactly how we have the ATP200 programmed. It does not pass vlan7 or vlan10 from the VPN100 to the network.0
-
Maybe you need to make VLAN 7 and 10 on the ATP200 base port LAN1 then add them in the Bridge?
0 -
I tried that, the issue was that then the vlan7 dhcp started serving up addresses on the native vlan.0
-
@MartyWalter
Regarding to this case,
The ATP200 doesn't support VLAN trunk on bridge mode. It supports mainly un-tagged traffic.
0
Categories
- All Categories
- 434 Beta Program
- 2.7K Nebula
- 174 Nebula Ideas
- 117 Nebula Status and Incidents
- 6.1K Security
- 418 USG FLEX H Series
- 297 Security Ideas
- 1.6K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 43 Wireless Ideas
- 6.7K Consumer Product
- 270 Service & License
- 416 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.1K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 83 About Community
- 87 Security Highlight