Policy Control is Not Working

Options
AlbertKang
AlbertKang Posts: 2 image  Freshman Member
First Comment
edited April 2021 in Security


IPs other than IPs of Test2 should not be connected, but access is possible.

Accepted Solution

  • Zyxel_Stanley
    Zyxel_Stanley Posts: 1,435 image  Zyxel Employee
    100 Answers 1000 Comments Friend Collector Eighth Anniversary
    Answer ✓

    Hi @AlbertKang  

    In the default policy control rules, there is no rule to allow the traffic from WAN to LAN.

    And also in the last rule, it has blocked the traffic those doesn't allowed.

    You may double confirm if there is any rule allows the traffic and check the last rule is stay in “deny” or “reject”.


All Replies

  • Zyxel_Stanley
    Zyxel_Stanley Posts: 1,435 image  Zyxel Employee
    100 Answers 1000 Comments Friend Collector Eighth Anniversary
    Answer ✓

    Hi @AlbertKang  

    In the default policy control rules, there is no rule to allow the traffic from WAN to LAN.

    And also in the last rule, it has blocked the traffic those doesn't allowed.

    You may double confirm if there is any rule allows the traffic and check the last rule is stay in “deny” or “reject”.


  • AlbertKang
    AlbertKang Posts: 2 image  Freshman Member
    First Comment
    edited December 2020
    Thank you so much, but I can't see the setup screen after changing it to deny, so I'll try again after initializing it.
    It works very well.

Categories

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）