VLAN setup on USG110

mrwee · December 2020

Hi,

This should be pretty basic, but I'm really struggling getting it to work. Hopefully someone can spot the mistake

My problem is that clients on a configured SSID does not get any DHCP IP address and I have not been able to get a manually set client IP address to work either. Using untagged SSID works fine.

Setup:

Zyxel USG110 <-> Zyxel GS1920-48HP <-> Ubiquity UDM-Pro with Ubiquity AP's.

I would like to add an SSID using tagged VLAN10 for IoT devices.

VLAN config on USG110:

Image: https://us.v-cdn.net/6029482/uploads/editor/up/ehkw4lrjwb2r.png

Image: https://us.v-cdn.net/6029482/uploads/editor/8q/dwd7btf2ej2p.png

Policy Route on USG110:

Image: https://us.v-cdn.net/6029482/uploads/editor/2g/18m707rg7frg.png

VLANs on GS1920:

Image: https://us.v-cdn.net/6029482/uploads/editor/bs/zpv9fnafyvdc.png

Image: https://us.v-cdn.net/6029482/uploads/editor/jy/ckbnur7nb37s.png

VLAN Port for USG110:

Port for UDM-Pro:

Does this look correct from an Zyxel perspective?

mrwee · December 2020

Fixed! Removed the static VLAN config on GS1920, now it's working

Zyxel_Stanley · December 2020

Hi @mrwee

After created VLAN interface on USG110, then USG send out the traffic with VLAN tag.

So it means you have to setup correct VLAN setting and PVD(for client) on switch.

It’s good to know you have found reason.

VLAN setup on USG110

Accepted Solution

All Replies

Categories

Security Highlight

Security Help Center