Zywall 110 - Netbios names
Freshman Member
Upgraded firmware from 3.10(AAAA.1) to 4.30(AAAA.0). When I go to ping a NetBIOS name from LAN1_SUBNET to another computer on LAN1_SUBNET, the Zywall is resolving the name to a dead address.
ping john
"Pinging john.ZyXEL-USG [198.105.244.117] with 32 bytes"
Any ideas what I need to change to get the Zywall to recognize computer names and serve addresses correctly?
ping john
"Pinging john.ZyXEL-USG [198.105.244.117] with 32 bytes"
Any ideas what I need to change to get the Zywall to recognize computer names and serve addresses correctly?
0
Comments
-
Hello Adam,
For this case,
according to windows mechanism, since the both PCs are in the same subnet, the ping traffic will not flow into gateway.(PCs will communicate with each other directly) Therefore, USG will not control the communication between both of PCs. If ping is not working, please make sure the firewall of PC are turned off.
Moreover, I would like to know the topology of this scenario for check further.
Charlie
0
Zyxel Employee
Categories
- All Categories
- 164 Beta Program
- 1.7K Nebula
- 86 Nebula Ideas
- 62 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 50 Switch Ideas
- 907 WirelessLAN
- 27 WLAN Ideas
- 5.3K Consumer Product
- 172 Service & License
- 294 News and Release
- 65 Security Advisories
- 14 Education Center
- 911 FAQ
- 399 Nebula FAQ
- 249 Security FAQ
- 90 Switch FAQ
- 100 WirelessLAN FAQ
- 18 Consumer Product FAQ
- 55 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 51 Security Highlight
