ipsec disconnect
Ally Member
Hi, have configured an ipsec tunnel between Usg 1000 and USG 300 firmware(3.30 AQE.7 ITS-WK48-r74988).Approximately once a week , the tunnel breaks and does not rise until both gateways disable-enable VPN Connect(Phase 2).There are no errors in the gateway logs.
0
Comments
-
@jonatan
When the issue occur, Is the network connection still working?
Also, please Enable Nailed-Up on VPN connection page.
Go to Configuration>VPN>IPSec VPN>VPN connection> Press Show Advanced Setting>tick Nailed-UP
Charlie0 -
To monitor vpn connections, the connection is lost. In USG 1000 settings, the Nalied-UP setting is enabled(Application Scenario Site-to site is selected), and in USG 300 this setting is not available because Application Scenario Site-to-site with Dynamic Peer is selected.This is because on the USG 1000 - 3 side of the ISP and on the USG 300 - 2 side of the ISP.
0
Zyxel Employee
Categories
- All Categories
- 164 Beta Program
- 1.7K Nebula
- 86 Nebula Ideas
- 62 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 50 Switch Ideas
- 907 WirelessLAN
- 27 WLAN Ideas
- 5.3K Consumer Product
- 172 Service & License
- 294 News and Release
- 65 Security Advisories
- 14 Education Center
- 911 FAQ
- 399 Nebula FAQ
- 249 Security FAQ
- 90 Switch FAQ
- 100 WirelessLAN FAQ
- 18 Consumer Product FAQ
- 55 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 51 Security Highlight
