issue with high availability
Options
Hello,
I have an usg1100 that is not updating firmware.
It shows an error when updating, "device ha firmware update is in progress..." and then "Detect Device HA passive fail."
I would like to fix the fact that the passive fail but I am not the one that implemented that firewall.
Reading here: https://mysupport.zyxel.com/hc/en-us/articles/360010570539--ZyWALL-USG-How-to-set-up-Device-HA-Pro-on-ZyWALL-USG-appliances it seems that If i connect an rj45 cable from port 8 (ge8) of the active device to port 8 (ge8) of the passive device It should bring up high availability again. Is that correct?
Watching this screen capture from the active device, it also seems that the high availability has never been implemented, or that currently the passive device is unplugged, am I correct?
I have an usg1100 that is not updating firmware.
It shows an error when updating, "device ha firmware update is in progress..." and then "Detect Device HA passive fail."
I would like to fix the fact that the passive fail but I am not the one that implemented that firewall.
Reading here: https://mysupport.zyxel.com/hc/en-us/articles/360010570539--ZyWALL-USG-How-to-set-up-Device-HA-Pro-on-ZyWALL-USG-appliances it seems that If i connect an rj45 cable from port 8 (ge8) of the active device to port 8 (ge8) of the passive device It should bring up high availability again. Is that correct?
Watching this screen capture from the active device, it also seems that the high availability has never been implemented, or that currently the passive device is unplugged, am I correct?
0
Accepted Solution
-
Hi @Hoygen83,
Can you try to update devices firmware one by one without set up before configuring Device HA environment and make sure partitions run same firmware version?
You need to connect 2 USG1100’s Port 8 to each other for HA setup.
Also if your setup is successful you have to see your Passive Device’s information in the Passive Device Status menu.
1
All Replies
-
Hi @Hoygen83,
Can you try to update devices firmware one by one without set up before configuring Device HA environment and make sure partitions run same firmware version?
You need to connect 2 USG1100’s Port 8 to each other for HA setup.
Also if your setup is successful you have to see your Passive Device’s information in the Passive Device Status menu.
1
Categories
- All Categories
- 384 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 79 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 909 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 209 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 898 Nebula FAQ
- 415 Security FAQ
- 234 Switch FAQ
- 205 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 62 Security Highlight