SSL VPN Problem with "consumer" router
Hi everyone. this is my first time using firewall for VPN, previously i was using openVPN only.
i have problems with creating simple SSL VPN: i can connect, but can't access to other devices on the LAN.
i'm using a zyxel USG20. because i can't set the isp router to bridge, i set thw WAN with an IP on same network range of the isp router and then in the router i activated DMZ to the ip address of the wan port of the firewall.
i have another customer with same configuration, but the wan is set with the public ip address (i think router is set to bridge mode), and VPN works.
so, the only difference is the isp router configuration. is there any way to get VPN works with non-bridge mode router?
i have problems with creating simple SSL VPN: i can connect, but can't access to other devices on the LAN.
i'm using a zyxel USG20. because i can't set the isp router to bridge, i set thw WAN with an IP on same network range of the isp router and then in the router i activated DMZ to the ip address of the wan port of the firewall.
i have another customer with same configuration, but the wan is set with the public ip address (i think router is set to bridge mode), and VPN works.
so, the only difference is the isp router configuration. is there any way to get VPN works with non-bridge mode router?
0
All Replies
Zyxel Employee
Categories
- All Categories
- 184 Beta Program
- 1.7K Nebula
- 89 Nebula Ideas
- 63 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 51 Switch Ideas
- 915 WirelessLAN
- 27 WLAN Ideas
- 5.4K Consumer Product
- 174 Service & License
- 295 News and Release
- 65 Security Advisories
- 14 Education Center
- 983 FAQ
- 426 Nebula FAQ
- 255 Security FAQ
- 100 Switch FAQ
- 115 WirelessLAN FAQ
- 21 Consumer Product FAQ
- 66 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 52 Security Highlight
