Device Insight Management
![[Deleted User]](https://us.v-cdn.net/6029482/uploads/defaultavatar/nN4PAQRO7TCNP.jpg)
[Deleted User]
Posts: 0
in Security
How can you remove devices that were previously discovered by the Device Insight service?
0
Accepted Solution
-
You missed space between e and _0
All Replies
-
I enabled the Device Insight option to see what it can do for me. After running it for a few weeks I didn't see a lot of value add in my particular network. It also used up CPU cycles that I couldn't afford to lose. I have since disabled the Device Insight option on my USG. However, when I go into the USG under "monitor", "Network Status", "Device Insight", the list of discovered devices is still populated in the list. I was wondering how to return the USG to show nothing in that list as if I never enabled it. This is purely a housekeeping item for me. I was hoping there was a command to flush the device insight table perhaps of devices no longer reporting? It there a table keep alive?0
-
When I issue that command, I get the following error:
Router(config)# device_debug flush device-list% (after 'terminal'): Parse errorretval = -1ERROR: Parse error/command not found!Router(config)#0 -
Thank you!0
Categories
- 6.9K All Categories
- 2 Education Center
- 1.4K Nebula
- 34 Nebula Ideas
- 40 Nebula Status and Incidents
- 3.9K Security
- 203 Security Ideas
- 753 Switch
- 31 Switch Ideas
- 638 WirelessLAN
- 10 WLAN Ideas
- 4.6K Consumer Product
- 105 Service & License
- 224 News and Release
- 39 Security Advisories
- 522 FAQ
- 239 Nebula FAQ
- 121 Security FAQ
- 73 Switch FAQ
- 67 WirelessLAN FAQ
- 6 Consumer Product FAQ
- Documents
- 30 Nebula Monthly Express
- 45 About Community
- 32 Security Highlight