port speed

Hi, the WAN port 1 of a USG60 connect on 100Mbs and not on 1Gbs anymore.

can I change that?


Accepted Solution

  • CHS
    CHS Posts: 177  Master Member
    First Anniversary 10 Comments Friend Collector First Answer
    edited July 2021 Answer ✓
    In UI, you can change port configuration as 1000Mbps Full Duplex manually.
    In usual it will auto negotiation as 1000M Full by default setting if without any interoperability between 2 devices.
    You can check if your (1) cable (2) WAN side device are support to 1000Mbs.
    The worse case, you can connect a switch between USG and your WAN side device.


All Replies

  • CHS
    CHS Posts: 177  Master Member
    First Anniversary 10 Comments Friend Collector First Answer
    edited July 2021 Answer ✓
    In UI, you can change port configuration as 1000Mbps Full Duplex manually.
    In usual it will auto negotiation as 1000M Full by default setting if without any interoperability between 2 devices.
    You can check if your (1) cable (2) WAN side device are support to 1000Mbs.
    The worse case, you can connect a switch between USG and your WAN side device.


  • kolicivu
    kolicivu Posts: 3
    edited December 2021
    CHS said:
    In UI, you can change port configuration as 1000Mbps Full Duplex manually.
    In usual it will auto negotiation as 1000M Full by default setting if without any interoperability between 2 devices.
    You can check if your (1) cable (2) WAN side device are support to 1000Mbs.
    The worse case, you can connect a switch between USG and your WAN side device.


    thank you.
  • CHS said:
    In UI, you can change port configuration as 1000Mbps Full Duplex manually.
    In usual it will auto negotiation as 1000M Full by default setting if without any interoperability between 2 devices.
    You can check if your (1) cable (2) WAN side device are support to 1000Mbs.
    The worse case, you can connect a switch between USG and your WAN side device.


    thank you.

Security Highlight