port speed

kolicivu

Hi, the WAN port 1 of a USG60 connect on 100Mbs and not on 1Gbs anymore.

can I change that?

CHS

In UI, you can change port configuration as 1000Mbps Full Duplex manually.
In usual it will auto negotiation as 1000M Full by default setting if without any interoperability between 2 devices.
You can check if your (1) cable (2) WAN side device are support to 1000Mbs.
The worse case, you can connect a switch between USG and your WAN side device.

CHS

In UI, you can change port configuration as 1000Mbps Full Duplex manually.
In usual it will auto negotiation as 1000M Full by default setting if without any interoperability between 2 devices.
You can check if your (1) cable (2) WAN side device are support to 1000Mbs.
The worse case, you can connect a switch between USG and your WAN side device.

kolicivu

CHS said:

In UI, you can change port configuration as 1000Mbps Full Duplex manually.
In usual it will auto negotiation as 1000M Full by default setting if without any interoperability between 2 devices.
You can check if your (1) cable (2) WAN side device are support to 1000Mbs.
The worse case, you can connect a switch between USG and your WAN side device.

thank you.

kolicivu

CHS said:

In UI, you can change port configuration as 1000Mbps Full Duplex manually.
In usual it will auto negotiation as 1000M Full by default setting if without any interoperability between 2 devices.
You can check if your (1) cable (2) WAN side device are support to 1000Mbs.
The worse case, you can connect a switch between USG and your WAN side device.

thank you.