NSW100 - SNMP support?

JCKelly
JCKelly Posts: 8  Freshman Member
First Anniversary First Comment
edited August 2022 in Switch
Does NSW100-28P support SNMP? If so, how do I add the feature? I've got a few of these in stock, but we were never able to figure out how to get SNMP running. It would be great if we could get these working with Domotz for monitoring and to get network maps. Failing that, does anyone want to buy them? I have two or three that were never opened and one in use in our lab.

Accepted Solution

  • Zyxel_Chris
    Zyxel_Chris Posts: 653  Zyxel Employee
    First Anniversary 10 Comments Friend Collector First Answer
    Answer ✓
    @JCKelly
    SNMP setting is in Site-wide> General settings, scroll down then you can find it.  :)
    Chris

All Replies

  • Zyxel_Chris
    Zyxel_Chris Posts: 653  Zyxel Employee
    First Anniversary 10 Comments Friend Collector First Answer
    Answer ✓
    @JCKelly
    SNMP setting is in Site-wide> General settings, scroll down then you can find it.  :)
    Chris
  • JCKelly
    JCKelly Posts: 8  Freshman Member
    First Anniversary First Comment
    Thank you, very helpful. Do you know where I'd find the MIB?
  • Zyxel_Chris
    Zyxel_Chris Posts: 653  Zyxel Employee
    First Anniversary 10 Comments Friend Collector First Answer
    @JCKelly
    SNMP feature on NSW series only support ES-common (enterprise solution) which shows basic information like device name, system uptime, firmware veresion, etc.
    Please find the attached.

    Chris
  • JCKelly
    JCKelly Posts: 8  Freshman Member
    First Anniversary First Comment
    Thanks Chris, I think I might be getting closer to the answer. Does the NSW100-28P support RFC 4188?  I understand that this is what is required for site mapping.
  • Zyxel_Chris
    Zyxel_Chris Posts: 653  Zyxel Employee
    First Anniversary 10 Comments Friend Collector First Answer
    edited March 2022
    @JCKelly
    I'm sorry, but NSW not support RFC4188.
    Chris