NSW100 - SNMP support?
Does NSW100-28P support SNMP? If so, how do I add the feature? I've got a few of these in stock, but we were never able to figure out how to get SNMP running. It would be great if we could get these working with Domotz for monitoring and to get network maps. Failing that, does anyone want to buy them? I have two or three that were never opened and one in use in our lab.
0
Accepted Solution
All Replies
-
Thank you, very helpful. Do you know where I'd find the MIB?0
-
@JCKelly
SNMP feature on NSW series only support ES-common (enterprise solution) which shows basic information like device name, system uptime, firmware veresion, etc.
Please find the attached.
Chris
0 -
Thanks Chris, I think I might be getting closer to the answer. Does the NSW100-28P support RFC 4188? I understand that this is what is required for site mapping.0
-
Categories
- 6.8K All Categories
- 1.4K Nebula
- 29 Nebula Ideas
- 37 Nebula Status and Incidents
- 3.9K Security
- 200 Security Ideas
- 723 Switch
- 30 Switch Ideas
- 599 WirelessLAN
- 8 WLAN Ideas
- 4.5K Consumer Product
- 98 Service & License
- 214 New and Release
- 38 Security Advisories
- 512 FAQ
- 237 Nebula FAQ
- 117 Security FAQ
- 72 Switch FAQ
- Network Reliability
- Network Security
- IPTV
- Layer 3 Switching & Routing
- Surveillance / ONVIF
- Other Topics
- 65 WirelessLAN FAQ
- 5 Consumer Product FAQ
- Documents
- 30 Nebula Monthly Express
- 43 About Community
- 31 Security Highlight