ZyWALL USG 100 Firmware restore via FTP failed!!!
Options
These days I tried to update the firmware via FTP, and then the device cannot be started, I connected the serial port, and the following information is displayed.
I update the firmware according to the prompt FTP connection, and then it keeps saying that it failed, I don't know what to do.I was writing this question and suddenly realized that I used the firmware of the usg100-plus on the usg100. Well, it seems I can't figure it out.
0
All Replies
-
Hi @Bob_1,
Welcome to Zyxel community. In the process of firmware recovery, if you find the error messages "extract_fw_info: Fail = 255" on console, you may check Windows Firewall settings and disable Windows Firewall temporarily on your laptop.
Ref: https://community.zyxel.com/en/discussion/12943/recovery-steps-for-usg-flex-atp-series-application-patrol-signature-issue/p10
Categories
- All Categories
- 398 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 83 Nebula Status and Incidents
- 5.2K Security
- 99 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 923 WirelessLAN
- 35 WLAN Ideas
- 5.9K Consumer Product
- 212 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2.1K FAQ
- 1K Nebula FAQ
- 445 Security FAQ
- 238 Switch FAQ
- 213 WirelessLAN FAQ
- 47 Consumer Product FAQ
- 142 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight