Bugs in last firmware

Dadv
Dadv Posts: 8  Freshman Member
First Comment
edited April 2021 in Security
Hi, i have found some bugs in the last firmware update (V1.00(AAKO.9))

- Qos => class setup => add or edit => impossible to add IP address
- Qos => class setup => add or edit => the Classificaiton Order  dropdown is not in sync with the real index of the rule (the sort is done like string, not as number)
- Qos => Monitor => Queue monitor vanish...

All Replies

  • CHS
    CHS Posts: 181  Master Member
    5 Answers First Comment Friend Collector Sixth Anniversary

    Hi @Dadv

    I just test it on my device, seems without problem.

    And dropdown view is correct.

    Did you select Ether type as IP(0x0800) when you adding the rule?

  • Dadv
    Dadv Posts: 8  Freshman Member
    First Comment
    Hi, thx for the reply,

    Yes I did it :





    But : 


  • Dadv
    Dadv Posts: 8  Freshman Member
    First Comment
    edited July 2018
    Just see you put a subnet mask to 255.255.255.255, but mine is 255.255.255.0 ...

    Also, if let it blank it's not working, in version 0.6 it was working in blank and 255.255.255.0
  • Zyxel_Stanley
    Zyxel_Stanley Posts: 1,377  Zyxel Employee
    100 Answers 1000 Comments Friend Collector Seventh Anniversary
    Hi @Dadv

    The address field was defined that the “address” must be a signal IP address or a IP subnet address. So you need to enter the correct mask in the field.

    If you entered mask as 255.255.255.0 then IP address should be 192.168.1.0 but not a IP address.

    This behavior was changed in V1.00(AAKO.9).

  • Dadv
    Dadv Posts: 8  Freshman Member
    First Comment
    OK understand for that, i'll change my mask for what i need.

    Any clue about the other bug?

Categories

Security Highlight


Read more

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）