Update zyxel USG FLEX 100 (4.55 to 5.21)
Options
Hello everyone,
I have a zyxel USG FLEX 100 and I need to update it. However, it is in version 4.55 and I would like to upgrade it to 5.21. Normally, I would have to go through intermediate versions but these are not available since the ftp has been closed.
Do you have a link to get the old versions of this firmware or should I update directly to 5.21? In the last case, I would have to do a reset and then restore my configuration?
0
Best Answers
-
0
-
Hi @Wassim,You can upgrade USG FLEX 100 from 4.55 to 5.21 directly. Before upgrading, remember to back up startup-config.conf of firmware 4.55. Then upload firmware 5.21 to standby firmware partition. More details can be found in this discussion.1
All Replies
-
0
-
Hi @Wassim,You can upgrade USG FLEX 100 from 4.55 to 5.21 directly. Before upgrading, remember to back up startup-config.conf of firmware 4.55. Then upload firmware 5.21 to standby firmware partition. More details can be found in this discussion.1
Categories
- All Categories
- 384 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 79 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 909 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 209 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 898 Nebula FAQ
- 415 Security FAQ
- 234 Switch FAQ
- 205 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 62 Security Highlight