CLI Ping getting failed results
Options
CLI Command on Zyxel USG Flex 200 not getting results I should
The LAN IP is 172.16.24.1
I can ping 8.8.8.8 from the Gui Diags, but when I go to the CLI and use this command it does not work
ping 8.8.8.8 source 192.16.24.1 (It fails all 3 packets)
OR
ping 8.8.8.8 source 192.16.24.1 interface wan1 (It fails all 3 packets)
OR
ping 8.8.8.8 source 192.16.24.1 interface eth2 (It fails all 3 packets) )eth2 is wan1 Interface)
The LAN IP is 172.16.24.1
I can ping 8.8.8.8 from the Gui Diags, but when I go to the CLI and use this command it does not work
ping 8.8.8.8 source 192.16.24.1 (It fails all 3 packets)
OR
ping 8.8.8.8 source 192.16.24.1 interface wan1 (It fails all 3 packets)
OR
ping 8.8.8.8 source 192.16.24.1 interface eth2 (It fails all 3 packets) )eth2 is wan1 Interface)
0
All Replies
-
Hi @Gazoo271,
Welcome to Zyxel community.
Is this IP 192.16.24.1 FLEX200 wan interface I P? and it can be routed to Internet by your ISP?
EDIT:
BTW, it is unable ping to Internet from firewall internal interface IP.0
Categories
- All Categories
- 390 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 78 Nebula Status and Incidents
- 5.1K Security
- 51 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 332 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 880 Nebula FAQ
- 415 Security FAQ
- 220 Switch FAQ
- 195 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 63 Security Highlight